Make-noise René Manual de usuario descargar pdf (Pagina 5)

René Panel Controls

Inputs:

1. X- CLK Input: clock/ gate signal (of width greater than .5ms and amplitude greater than 2.5V) applied

to this input drives the X- Axis Counter. If using MATHS to clock, then set Vari- Response to

LINEAR. When René counts Snake Style, X- CLK steps linearly through a stored set of

coordinates; it drives the sequence.

2. X- MOD Input: The state of this input (either HI or LO) further determines behavior of René depending

upon the selections made in the X- Fun PGM Page. For example, when CLK- RST is selected

under X- Fun a logic HI at this input will Reset the X- Axis Counter to 0.

3. X- CV Input: control signal at this input generate a number that is added to the number generated by

the X- Axis Counter, to create the X coordinate. When René counts Snake Style, X- CV scans

linearly through a stored set of coordinates. X- CV is normalled to +5V so that with nothing

patched the attenuator acts as offset generator

4. X-CV Input CV Attenuator

5. Y- CLK Input: clock/ gate signal (of width greater then .5ms and amplitude greater then 2.5V) applied

to this input drives the Y- Axis counter. If using MATHS to clock, then set Vari- Response to

LINEAR. When René counts Snake Style, Y- CLK selects stored coordinates set.

6. Y- MOD Input: The state of this input (either HI or LO) further determines behavior of René depending

upon the selections made in the Y- Fun PGM Page. For example, when Glide is selected under

Y- Fun a logic HI at this input will engage the glide function.

1 2 3 4 5 6 7 8 9 10 11 12

Sin comentarios

Make-noise René Manual de usuario Pagina 5